![]() Recommended operating pressure is 40 PSI. The Pulse XL replaces pop-up impact rotors from Orbit, Hydro-Rain, and other major brands. male pipe thread (MPT) riser into the bottom inlet or a 1/2-in. The typical method for installing or replacing a pop-up impact is on a 1/2-in. A slotted plug seals whichever inlet is not in use. female pipe thread (FPT) and the bottom inlet is both 1/2-in. You can create a full pattern by simply flipping the trip pin up. Arc adjustment stops make setting the pattern simple and tool free. ![]() The can and riser stem are made from high-impact ABS and the metal components are made from stainless steel. It includes a radius adjustment screw which allows you to reduce the impact throw down to 75% of its rated distance. The 4 GPM and 2 GPM bonus nozzles allow you to create a matched precipitation effect for full (yellow nozzle), half (pre-installed nozzle), and quarter (red nozzle) patterns. This very low rate reduces the risk of runoff or puddling for many soil types and conditions. It comes with a pre-installed 3-gallon-per-minute (GPM) nozzle which results in a full-pattern precipitation rate of 0.18 in. pop-up height ensures that the nozzle clears tall grass. The rolled lip surrounding the outside of the can creates a donut ring which prevents grass from growing into it. Its arc is adjustable from 20 to 360 degrees, which gives you the ability to aim it so that the water hits the landscape only and avoids any hardscape surfaces. It is ideal for landscape areas which require a throw distance of up to 45 ft. The double-weighted impact arm ensures reliable operation even under high pressure. Turn the screwdriver clockwise to reduce radius, and counterclockwise to increase the radius.The Pulse XL pop-up impact sprinkler is engineered to handle the demands of high-mineral content, dirty, and reclaimed water without clogging.Insert a screwdriver into the radius adjustment socket of the rotor.Do not adjust the rotor beyond the maximum or minimum arc. When the maximum arc of 360 degrees or minimum arc of 40 degrees has been set, you will hear a ratcheting noise.Each full clockwise turn of the screwdriver will add or remove 90 degrees of arc.Turn the screwdriver counterclockwise, (-) to DECREASE arc. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |